Bf-430 Is A Low Cost Small (2.6'' X 3.6'') Industrial Single Port Rs232 Or Rs485 Serial Device Server That Can Make Your Industrial Serial Devices To Be Ip / Ethernet Network Enabled. Configuration And Firmware Upgrade Are Available Using The Network. Pppoe & Ddns Protocol Makes The User Connect To Internet Without Static Ip.The Bf-430 Is Easy To Configure Using A Simple Web Page Configuration Page. The Terminal Block On The Bf-430 Is Used For Power Connection And/Or Rs485 Operation. The Rs232 Connection Is A Standard Db9 Male. The Power Connection (9-30Vdc) Can Be Made Using The Included Wall Supply With Barrel Plug Or Wired In Directly To The Terminal Block.
⚠️ WARNING (California Proposition 65): This product may contain chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. For more information, please visit www.P65Warnings.ca.gov.
Frequently Asked Questions
Q: What are the dimensions of the Industrial Serial RS232 Ethernet & RS485 Converter?A: The dimensions are two point six inches in height, zero point nine inches in width, and three point seven inches in length.
Q: What is the power supply requirement for the BF-430?A: It requires a power supply between nine and thirty volts direct current.
Q: What materials is the BF-430 made from?A: The converter is made from metal, ensuring durability and reliability in industrial settings.
Q: How do I configure the Industrial Serial Converter?A: You can configure the BF-430 using a simple web-based configuration page accessible through your network.
Q: Is the BF-430 suitable for connecting multiple devices?A: No, the BF-430 is a single port device, designed to connect one RS232 or RS485 device to an Ethernet network.
Q: Can I use the BF-430 for remote device management?A: Yes, it supports full network management via web, allowing for remote monitoring and control of connected devices.
Q: How do I ensure the BF-430 is safe from power surges?A: The device includes surge protection for the serial port, rated at fifteen kilovolts electrostatic discharge.
Q: What protocols does the BF-430 support for internet connectivity?A: It supports PPPoE, Dynamic DNS, and DHCP for seamless internet connectivity without needing a static IP.
Q: How do I maintain the BF-430 for optimal performance?A: Keep the device clean and ensure proper ventilation; avoid exposing it to extreme temperatures or moisture.
Q: What should I do if the BF-430 does not power on?A: Check the power supply connection and ensure it matches the required voltage between nine and thirty volts.
Q: Is there a warranty for the BF-430?A: Yes, the BF-430 typically comes with a manufacturer's warranty; please check with the seller for specific terms.
Q: How can I reset the BF-430 to factory settings?A: Refer to the user manual for instructions on performing a factory reset using the web interface.
Q: Is the BF-430 compatible with all types of industrial serial devices?A: It is compatible with any RS232 or RS485 device, but ensure that the device's baud rate is supported.
Q: What is the baud rate range for the BF-430?A: The baud rate range for the BF-430 is from one thousand two hundred bps to two hundred thirty point four kbps.
Q: Can I upgrade the firmware on the BF-430?A: Yes, the firmware can be upgraded over the network, ensuring your device stays up to date.
Q: Does the BF-430 require any special software to operate?A: No special software is required; it can be managed through any standard web browser.
