We will send you an email to reset your password.
Vendor: Electroeshop
Type:
Sku: 14:29#ICS-43434
Availability: In Stock
Couldn't load pickup availability
Sold by Electroeshop, an authorized reseller.
Returns accepted within 30 days | support@electroeshop.com
Returns accepted within 30 days of delivery.
Damaged or Defective Item
Free return shipping + replacement or full refund
Wrong Item Received
Free return shipping + replacement or full refund
Change of Mind
Return shipping at customer's expense · 25% restocking fee applies
Brand Name: NONE
High-concerned chemical: none
Origin: Mainland China
Description
Listen to the good news - we now have a super small breakthrough board ICS43434 I2MEMS microphone. Just like "classic" element microphones, MEMS MIC can detect sound and convert it into voltage, but they are smaller and thinner. This microphone isn't even analog, it's purely digital. The I2S is a small, low-cost MEMS MIC with a range of about 50Hz-15kHz, suitable for all general purpose audio recording/detection. The chip has a built-in low-pass filter that cuts the frequency above 24kHz.
For many microcontrollers, adding audio input is easy with one of our analog microphone breakthroughs. But as you get to bigger and better microcontrollers and microcomputers, you'll find that you don't always have analog inputs, or maybe you want to avoid the noise that seeps in with analog microphone systems. Once past the 8-bit micros, you'll usually find that I2 can take the peripheral digital audio data in! That's where the I2S microphone breaks through the featured TDK ICS43434 in.
Instead of the analog output, there are three digital pins: clock, Data, and Left/Right (Word Select) clock. When connected to a microcontroller/computer, the "I2S controller" will drive the clock and word select pins at high frequencies and read data from the microphone. No analog conversion required!
A microphone is a single unit element. You can Select the Select Pin on the left or right channel by connecting it to power or ground. If you need stereo sound, pick up two microphones! You can set them to stereo by sharing the clock, WS, and data lines, but with the one with the choice ground, a person with the choice can choose high voltage to high voltage. No firmware or driver configuration is required, and you'll get 24-bit output instantly.
This I2S MEMS microphone is bottom ported, so make sure you have holes on the bottom, towards the sound you want to read. It's only the largest device at 1.6-3.6V, so it won't work with 5V logic (you're unlikely to use an I2S 5V logic device anyway). Many beginner microcontroller boards don't have i2, so make sure it's a supported interface before trying to put it all together! The microphone is best used with cortical M-series chips such as SAMD21 or SAMD51, ESP32, RP2040 or RP2350, or RASPBERRY PI (e.g. Raspberry Pi).
argument
Sensitivity: −26 dB FS ±1dB
High performance mode SNR: 65 dBA
Low power mode SNR: 64 dBA
High performance mode current consumption: 490 µA
Low power mode Current consumption: 230µA
Mike Wind Pressure Level Overload Point (AOP) : 120 dB SPL
High performance mode sampling rate: 23 ~ 51.6kHz
Low power mode sampling rate: 6.25 ~ 18.75 kHz







⚠️ WARNING (California Proposition 65):
This product may contain chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.
For more information, please visit www.P65Warnings.ca.gov.