Introduction LCD1602 is an industrial character type LCD that can show 16*2, i.e. 32 characters. The character generator ROM in the LCD module has already stored 160 different characters in dot matrix, including Arabic numbers, letters in low and upper case, and common symbols. compatible with Arduino IDE, a built-in library LiquidCrystal can be called directly, and you dont need to write it, which is pretty convenient for beginners. Its working voltage is 5V, and you can adjust the contrast via the 50K potentiometer. For the backlight, just connect pin A to 3.3V and K to GND, and then it will light up. Note: You need to solder the Pin Headers before application. Pins of LCD1602 and their functions: VSS: connected to ground VDD: connected to a +5V power supply VO: to adjust the contrast RS: A register select pin that controls where in the LCDs memory you are writing data to. You can select either the data register, which holds what goes on the screen, or an instruction register, which is where the LCDs controller looks for instructions on what to do next. R/W: A Read/Write pin to select between reading and writing mode E: An enabling pin that, when low-level energy is supplied, causes the LDC module to execute relevant instructions. D0-D7: to read and write data A and K: Pins that control the LCD backlight For more details, refer to our WIKI page: http://wiki.sunfounder.cc/index.php?title=LCD1602_Module Package Included: -1 x LCD1602 -16 x Pin Headers
⚠️ WARNING (California Proposition 65): This product may contain chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. For more information, please visit www.P65Warnings.ca.gov.
