Description:1.Size: 18.4*16mm2.Input voltage:3V-10V3.Single H-Bridge output current: 1.5A( It can drive two DC motor)4.Overcurrent protection: Yes5.Short circuit protection: Yes6. undervoltage lockout: Yes7.Overheating protection: Yes8.With a low-power sleep mode Feature:1.ULT pin: mode set. Low level is sleep mode2.OUT1, OUT2: 1-channel H-bridge controlled by IN1/IN2.3.OUT3, OUT4: 2-channel H-bridge controlled by IN3/IN44.EEP PIN: Output protection. Default no need to connect.5.VCC:3-10V Directions for useEEP low level is sleep mode(need to disconnect the J1 short contact behind the module, the module is connected by default and connected to the high level).Out1, out2 are H bridges of one way, and corresponding control of points is In1, In2.Out3 and out4 are the 2nd H bridge, and the corresponding control is In3, In4.ULT outputs for protection alarm, and outputs low level alarm signals when overheat and overcurrent protection is in effect. Application:1.DC motor which drive current is less then 1.5A2.4-wire step motor3.Single H bridge output maximum current protection, undervoltage lockout and overheat protection. With low-powersleep mode. 4.Use: can drive the following 1.5A DC motor and 4- wire steppermotor Package included:10pcs DRV8833 Motor Drive Module
⚠️ WARNING (California Proposition 65): This product may contain chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. For more information, please visit www.P65Warnings.ca.gov.
