Matte Fiber HT PLA Walnut Wood - 500g Spool. Material DataBase resin: HTPLA - Heat Treatable PLAParticle size: less than 250 microns (0.25mm)Odor: low or noDensity: Approx. 2.30 g/ccLength (500g): 97m (1.75mm) and 36m (2.85mm)Heat treating: 110C (225F) for 10 min or as required for the desired resultTotal loss of stiffness (before heat treat): 50-60C (Tg)Total loss of stiffness (after heat treat): 150-175C (melting)Dimension change (before heat treat): 0% X/Y/ZDimension change (after heat treat): 1.5% shrink X/Y and 1% growth Z typical but please calculate and confirm for your specific print and processPrinter SettingsSpeed: 10-20 mm/s 1st layer, 20-80 mm/s rest of partNozzle Set-point: 185-215C (hottest on 1st layer for best adhesion)Nozzle Actual: maintain set-point, reduce speed if less thanNozzle Type: Standard or wear-resistant for extended useNozzle Diameter: 0.6mm or larger preferred, 0.4mm okay with 0.25mm minimum for expertsLayer thickness: 0.15-0.20mm recommended for a balance of quality, reliability, and productivityBed Temperature: Room-60C (over 60C can worsen warp)Bed Preparation: Elmers purple disappearing glue stick or your other favorite PLA surface preparation
⚠️ WARNING (California Proposition 65): This product may contain chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. For more information, please visit www.P65Warnings.ca.gov.
