Waveshare For Raspberry Piarduinostm32, 151 Transparent Oled Screen With Expansion Board, 128X64 Pixels Light Blue Color Display,33V 5V Voltage, Spii2C Interfaces (151 Oled 128X64-N)
$35.59
Taxes will be calculated at Checkout.
US Delivery Time: 3-5 Business Days.
US Delivery Time: 3-5 Business Days.
Product Description
Waveshare For Raspberry Piarduinostm32, 151 Transparent Oled Screen With Expansion Board, 128X64 Pixels Light Blue Color Display,33V 5V Voltage, Spii2C Interfaces (151 Oled 128X64-N)
OLED controller The integrated built-in controller used by this OLED is SSD1309, which has 128 x 64 bits SRAM, supports up to 128 x 64 pixel screen, supports SPII2c 6800 parallel port8080 parallel port, 256-level brightness settings, this screen is 128 A 64 pixels, so the internal SRAM is not fully used This module adopts four-wire SPI and I2c interfaces, with good compatibility and high transmission speed Online guidedocument: n9clzcqtf Specifications Working Voltage: 5V33V communication Interface: SPII2c controller: SSD1309 Resolution: 128 x 64 Display Size: 3505 x 1532 (mm) Pixel Size: 0254 x 0254 (mm) Board Size: 41 x 225 (mm) Display color: Light Blue Package content 151inch Transparent OLED x1 PH20 7PIN cable x1 Screws pack FAQ 1Question:How many volts can an OLED module be used in a system Answer: The OLED module is used in a 33V system by default, but after more than 24 hours of the burn-in test, it is found that it can also work normally in a 5V system 2Question:How many hours is the service life of an OLED module Answer:generally it is 50,000 hours under normal working conditions 3Question:What should I pay attention to when using this OLED module Answer: 1 Be careful not to connect the power supply in reverse 2 The same picture cannot be displayed for a long time, or there will be afterimages and cause damage to the OLED 4Question:Why does the OLED module not turn on when it is connected to the power supply Answer: OLED does not have a backlight, and the display is self-illuminating Only connect Vcc and gND, and the OLED will not light up Program control is required to brighten the OLEDFeatures of Waveshare For Raspberry Piarduinostm32, 151 Transparent Oled Screen With Expansion Board, 128X64 Pixels Light Blue Color Display,33V 5V Voltage, Spii2C Interfaces (151 Oled 128X64-N)
151 Transparent OLED Screen with Expansion Board,full viewing angle Embedded independent driver chip, Using SPII2c Interfaces SPI and I2c control interface switching, supports controller boards like Raspberry PiArduinoSTM32 Working Voltage: 5V33V communication Interface: SPII2c controller: SSD1309 Resolution: 128 x 64 Display Size: 3505 x 1532 (mm) Pixel Size: 0254 x 0254 (mm) Board Size: 41 x 225 (mm) Display color: Light Blue There are two driver interfaces on the OLED module: 4-wire SPI and I2c interfaces respectively Two resistors can be soldered on the back of the module The corresponding communication mode can be selected through the selection of resistorsSpecification of Waveshare For Raspberry Piarduinostm32, 151 Transparent Oled Screen With Expansion Board, 128X64 Pixels Light Blue Color Display,33V 5V Voltage, Spii2C Interfaces (151 Oled 128X64-N)
| Product Details | |
|---|---|
| Color | 1.51\ OLED" |
| Dimensions | 1.66X0.87X0.08 |
| Weight | 0.01 |
Warning - California Proposition 65 This product may contain chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.